Samsung OfficeServ 7200 Technical Manual page 21

OfficeServ 7200
TECHNICAL MANUAL
The LCP is a secondary processor that communicates with the MCP and manages the
boards in the expansion cabinet.
3.2.1 Setting Switches
The MCP board includes switches used for optimizing the board to the user
requirements and system configuration.
The procedure for setting switches is as follows.
On the MCP, set the switches for the required configuration. The description for the
settings is described below.
• Memory Backup Switch (S2): When set to ON, all system programming is saved in
SRAM even when system is rebooted or powered OFF. This will be saved in SRAM
until the Super Capacitor has been drained of all charge (this charge will last only
up to 2 days). At that point all programming will be lost. It is recommended all
programming is saved using Smart Media or OfficeServ Manager application.
Turning the switch OFF will set the system to DEFAULT. To default the system keep
this switch in the OFF position for 30 seconds. Switch to ON position before
powering up the system.
OFF
ON
S3
OFF
Figure 3.2 Switch Setting
3.3
Home Page
INSTALLATION
PART 3 SEPTEMBER 2005
Memory Back Up Switch
S2
ON
Table of Contents