Table of Contents
Advertisement
3.2.3 Special function registers (SFRs)
Unlike a general-purpose register, each special function register has a special function.
The special function registers are allocated in the 256-byte area of FF00H to FFFFH.
Special function registers can be manipulated, like general-purpose registers, by operation, transfer, and bit
manipulation instructions. The manipulatable bit units (1, 8, and 16) differ depending on the special function register
type.
The manipulatable bits can be specified as follows.
• 1-bit manipulation
Describes a symbol reserved by the assembler for the 1-bit manipulation instruction operand (sfr.bit). This
manipulation can also be specified with an address.
• 8-bit manipulation
Describes a symbol reserved by the assembler for the 8-bit manipulation instruction operand (sfr).
manipulation can also be specified with an address.
• 16-bit manipulation
Describes a symbol reserved by the assembler for the 16-bit manipulation instruction operand.
addressing an address, describe an even address.
Table 3-4 lists the special function registers. The meanings of the symbols in this table are as follows:
• Symbol
Indicates the addresses of the implemented special function registers. The symbols shown in this column are
the reserved words of the assembler, and have already been defined in the header file called "sfrbit.h" of the C
compiler.
Therefore, these symbols can be used as instruction operands if an assembler or integrated
debugger is used.
• R/W
Indicates whether the special function register in question can be read or written.
R/W:
Read/write
R:
Read only
W:
Write only
• Bit manipulation unit
Indicates the bit units (1, 8, 16) in which the special function register in question can be manipulated.
• After reset
Indicates the status of the special function register when the RESET signal is input.
CHAPTER 3 CPU ARCHITECTURE
User's Manual U15075EJ1V0UM00
This
When
65
Advertisement
Table of Contents
