Kenwood NX-5000 Series Function Reference page 36

1 DMR CONVENTIONAL SYSTEM
1.5 Making an Individual Call
3
Enter a Unit ID.
Refer to Common FUNC
method.
0
Using the PF keys
A numeric character can be selected by pressing the [G] key or the [H]
key, and pressing the Menu ([Q]) or [*] key can confirm the selected
numeric character.
0
Using the keypad
A Unit ID can be entered by pressing the [0] to [9] keys.
4
Initiating an Individual Call.
Press the PTT switch to initiate a Voice Call. The "
display changes to "Individual" and the ID name of the target transceiver.
Press the Menu ([Q]) or [*] key to initiate a Paging Call.
If Individual Call Mode has been entered with "Individual + Status" or
"Individual + Short Message", Status Mode or Short Message Mode is
entered by pressing the [F] key.
Note
The selection screen for the Individual ID List closes at the same time as
pressing the PTT switch. If selecting an ID and sending an Individual Call
again, reexecute the operations from step 1.
Note
If the Individual Call Mode previously used is Manual Dialing mode, the transceiver enters Manual Dialing mode by
0
pressing the Individual key. A selection screen for the Individual ID List will appear by pressing the Function [W] key.
If no ID is registered in the Individual ID List, the transceiver enters Manual Dialing mode by pressing the Individual key
0
if Manual Dialing is enabled. In this case, the transceiver cannot enter Individual Call Mode if Manual Dialing is disabled.
If Transmit LED is enabled, the LED lights red when the transceiver is transmitting. (Refer to Common FUNC
0
LED.)
If PTT Proceed Tone is enabled, a Proceed Tone (3 beeps) sounds from the transceiver when the transceiver becomes
0
ready for communications after the PTT switch is pressed. (Refer to Common FUNC
to Start Communications (PTT Proceed
Configuration using KPG-D1/ D1N
0
Assigning functions to the PF keys on the transceiver (
0
Configuring Manual Dialing to be enabled or disabled (
DMR Conventional > DMR)
0
Configuring Selcall on PTT (
on PTT)
0
Configuring Selcall on PTT (Channel Edit) (
Conventional > DMR > Selcall on PTT)
DMR FUNC (K, F)/Ver 2.20
"Entering or Deleting a Code" for the entry
Tone).)
Transceiver Settings > Personal > Personality > DMR Conventional > DMR > Selcall
Transceiver Settings > Zone/Channel > Channel Edit > DMR
" icon blinks, and the
Transceiver Settings > Key Assignment)
Transceiver Settings > Personal > Personal Features >
CONTENTS
12 : 34
Individual
UID
P ag e De let e
12 : 34
I n d i v i d u a l
T R U C K 8 2 4
M en u Zo ne+
Transmit
Using Sound to Notify the Timing
INDEX
A
M
1
A
M
19