Honeywell Electromechanical Blocking Element 3 Mounting And Connection Instructions page 18

18
The distance between the face plate and the threaded sleeve should be kept as small
as possible and should not exceed 4 mm.
A borehole is required in the frame (
necessary, this can be attached using the drilling jig or according to the dimensioned
drawing 3.1
The installation of the blocking element in magnetic conductive metals influences the
range of the magnet.
Do not use a face plate of magnetic conductive metal.
The face plate included in the scope of delivery of the blocking element 3
019032 is not of magnetic conductive material.
The lateral offset between the contact and the round magnet may not
exceed
The threaded sleeve
borehole according to the core diameter.
Borehole for threaded sleeve:
Material
Soft wood, plywood, particle
boards
Hard wood, MDF boards
These values are approximate values.
If necessary, establish the optimum borehole diameter by experimenting. The harder
the material, the larger the borehole diameter must be.
If the counter units (Item no. 019022 or 019023) are used, ensure that the
bolt can be closed completely (up to the end position). It may be necessary
to bore the counter unit at the back.
Mounting and Connection Instructions Blocking Element 3
10 mm in any direction.
(019020) is suitable for door leaves of wood and is turned into a
Borehole-Æ
19.5 to 20.0 mm
20.0 to 20.5 mm
Æ
6 mm) for mechanical emergency unlocking. If
Borehole depth
³28 mm