Table of Contents
Advertisement
1. Precautions of operation
Before turning ON power
Choose appropriate power source with correct voltage setting as the input voltage
specification of the inverter.
Special care must be taken while wiring the primary circuitry panel. The L1 and L2
terminal must be connected to input power source and must not be mistakenly
connected to T1, T2 or T3 terminal. This may damage the inverter when the power is
turned on.
l
Do not attempt to transport the inverter by the front of the cover. Securely hold the
inverter by the heat-sink mounting chassis to prevent the inverter from falling, this
may cause personnel injury or damage to the inverter itself.
l
Install the inverter onto a firm metal base plate or another non-flammable type
material. Do not install the inverter onto or nearby any flammable material.
l
An additional cooling fan may need to be installed if several inverters are installed
into one control panel. The inside temperature inside an enclosed panel should be
below 40 degrees to avoid overheating.
l
Turn off the power supply before proceeding to remove or perform any work on any
panel. Carry out installation procedures according to instructions given in order to
avoid a situation resulting in an operational malfunction.
l
Suitable for use on a circuit capable of delivering not more than 5000 RMS
symmetrical amperes. 240 Volts maximum.
l
This product is not provided with over speed protection.
l
Only intended for use in a pollution degree 2 macro environment or equivalent
When power is applied
Do not attempt to install or remove connector of inverter when the power supply is
turned on. Otherwise, the inverter may be damaged due to the surge peak caused by
the insertion or removal of power.
Chapter 1. Safety Precaution
CAUTION
WARNING
CAUTION
WARNING
2
Hide quick links:
Advertisement
Table of Contents
