Cisco 7513 Series Replacement Instructions Manual page 19

When the system starts up and operates successfully, the replacement procedure is complete, and
you can resume normal operation.
If the system still fails to start up or operate properly, or if you isolate the cause of the problem to a
failed component, contact a service representative for further assistance.
Note
parts. If the old chassis is still mounted in a rack, follow the steps in the section "Removing the
Existing Chassis from the Rack" on page 9 to remove it. Place spare interface processors or interface
processor fillers in the chassis slots, and move the chassis to the appropriate location for storage or
shipment.
Verifying the Installation Using show Command Descriptions and Examples
This section describes the various show commands that you can use to display system status and
configuration. If you installed the interface processors in the same slot locations that they occupied
in the old chassis, the interfaces should retain the same configuration. If you installed the interface
processors in different slot locations, the system will recognize the interfaces, but you will have to
use the configure command to reconfigure and enable them.
You can check the version of the default ROM image either by removing the board and checking the
ROM labels or by configuring the interface or system software to boot from ROM, restarting the
system, and using these same commands to check the running version.
Use the show version command to display the current system software version, and use the show
controllers cxbus command to display the microcode version of the SP and each interface
processor. In the following example of the show version command, the system software is
Release 10.3(571)).
Router> show version
GS Software (RSP-K), Version 10.3(571), SOFTWARE
Copyright (c) 1986-1995 by cisco Systems, Inc.
Compiled Wed 10-May-95 14:46 by mpo
System Bootstrap, Version 4.6(1) [fc2], SOFTWARE
Current date and time is Sat 1-22-1994 21:38:35
Boot date and time is Tue 12-28-1993 15:32:28
Router uptime is 3 weeks, 4 days, 6 hours, 7 minutes
System restarted by reload
System image file is "gs7-k.103-1", booted via tftp from 1.1.1.12
(example text omitted
X.25 software, Version 2.0, NET2 and BFE compliant.
Bridging software.
1 EIP controller (6 Ethernet).
1 TRIP controller (4 Token Ring).
6 Ethernet/IEEE 802.3 interfaces.
4 Token Ring/IEEE 802.5 interfaces.
(remainder of example text omitted)
After you verify a successful installation, gather the old chassis and any remaining spares and
Cisco 7513 Chassis Replacement Instructions
Replacing the Chassis
19