Setup Function - Honeywell FocusPRO TH6220D Installation Manual

Installation Guide
r
Follow the procedure below to configure the thermostat to match the installed
heating/cooling system, and customize feature opemdon as desired.
Function Setting
N®[]_BB number
To begin, press and hold the A and FAN
buttons until the display changes
Press A or Y to change settings
Press NaT to advance to next function
Press DaNE to exit and save settings
Setup Function
8 Emergency heat
cycle rate (CPH)
9 Compressor
cycle rate (CPH)
10 Second stage
compressor cycle
rate (CPH)
12 System setting
adjustment
Settings & Options
9 For electric emergency heat
1 For steam or gravity systems
3 For hot water systems & furnaces of over 90% efficiency
5 For gas or oil furnaces of less than 90% efficiency
)Other cycle rate options: 2, 4, 6, 7, 8, 10, 11 or 12 CPH)
Recommended for most compressors
)Other cycle rate options: 1, 2, 4, 5 or 6 CPH)
Recommended for most compressors
)Other cycle rate options: 1, 2, 4, 5 or 6 CPH)
0 Manual changeover (HeatlCool/Off)
1 Auto changeover (Heat/Cool/Auto/Off) **See page 14
2 Auto changeover only (Auto) **See page 14
13 Adaptive Intelli= 1 On **See page 14
gent Recove_
TM
O Off
14 Temperature 0 Fahrenheit
display 1 Celsius
15 Compressor
protection
16 Schedule format
27 Heat temperature
range stops
28 Cool temperature
range stops
5 Five-minute compressor off time **See page 14
[Other options: 0, 1, 2, 3 or 4-minute off time]
0 5/2 (pregremmable weekdays and weekends)
1 5/1/1 (weekdays, Saturday & Sunday programmable)
90 Highest heating temperature setting
40-89 Heating temperature range (increments of 1 °F, or 0.5°C)
50 Lowest cooling temperature setting
51-99 Cooling temperature range (increments of 1 °F, or 0.5°C)
12