Honeywell FocusPRO TH6220D Installation Manual page 19

FocusPRO
TM
TH6220D Programmable Thermostat
Heating equip- o Check Installer Setup, Function 1 (System Type), to make sure it is set to
merit is running match the installed heating/cooling equipment (see page 11).
in cool mode
Cannot change
system setting
to "Heat"
* Check Installer Setup, Function 1 (System Type), to make sure it is set to
match the installed heating equipment (see page 11).
Change Installer Setup, Function 12 (System Setting) to Manual or Auto
Chart eogeover(see page 12).
Cannot change
system setting
to "Cool"
* Check Installer Setup, Function 1 (System Type), to make sure it is set to
match the installed cooling equipment (see page 11).
* Change Installer Setup, Function 12 (System Setting) to Manual or Auto
Chart eogeover(see page 12).
"Heat Oil" is o
net displayed
"Cool On" is not *
displayed
"Cool On" or o
"Heat On"
is flashing
Change the System Setting to Heat, and set the temperature level above
the current room temperature.
Change the System Setting to Cool, and set the temperature level below
the current room temperature.
Compressor protection timeout is engaged. Wait 5 minutes for the
system to restart safely, without damage to the compressor.
Please contact your distributor to order replacement parts.
Battery holder ...................................................... Part Number 50007072-001
Cover plate assembly ........................................ Part Number 50002883-001
(Use to cover marks left by old thermostats,)
Temperature Ranges
Heat: 40 ° to 90°F (4.5 ° to 32°C)
o Cool: 50 ° to 99°F (10 ° to 37°C)
Electrical Ratings
Terminal Voltage (50/60Hz) Running Current
W (O/B) Heating 20-30 Vac 0.02-1.0 A
Operating Ambient Temperature
* 32 ° to 120°F (0 ° to 48.9°C) (Powerpile) 750 mV DC 100 mA DC
Shipping Temperature W2 (Aux) Heating 20-30 Vac 0.02-0.5 A
-20 ° to 120°F (-28.9 ° to 48.9°C) Y Cooling 20-30 Vac 0.02-1.0 A
Operating Relative Humidity Y2 Cooling 20-30 Vac 0.02-1.0 A
5% to 90% (non-condensing) G Fan 20-30 Vac 0.02-0.5 A
Physical Dimensions E Emergency heat 20-30 Vac 0.02-1.0 A
3-9/16" H x 5-13/16" W x 1-1/2" D
91 mm H x 147 mm W x 38 mm D L Heat pump reset 20-30 Vac 0.02-0.5 A
17