Sound pressure level (L ) : 70 dB(A) or less Cordless Screwdriver Uncertainty (K) : 3 dB(A) Model No./ Type: BFT041R, BFT082R, BFT124R The noise level under working may exceed 80 dB(A) are of series production and Wear ear protection...
Page 3
Makita International Europe Ltd. moving parts. Damaged or entangled cords Michigan Drive, Tongwell, increase the risk of electric shock. Milton Keynes, Bucks MK15 8JD, England When operating a power tool outdoors, use an extension cord suitable for outdoor use. Use of 30.1.2009...
GEB050-2 19. Disconnect the plug from the power source and/or the battery pack from the power tool CORDLESS SCREWDRIVER before making any adjustments, changing SAFETY WARNINGS accessories, or storing power tools. Such preventive safety measures reduce the risk of Hold power tool insulated...
Do not expose battery cartridge to water until it locks in place with a little click. If you can or rain. see the red part on the upper side of the button, it A battery short can cause a large current flow, is not locked completely.
Page 6
NOTE: Lighting up the lamps Use a dry cloth to wipe the dirt off the lens of lamp. • Be careful not to scratch the lens of lamp, or it may 1. Lamp lower the illumination. LED indicator / Beeper For LED#A 1.
Page 7
Lights up in red A series of short the tool stops. and green beeps alternatively Take it to a Makita This function works Failure of motor Authorized Service when motor fails. centers. This function works Remove the battery...
Page 8
Radio This function works Take it to a Makita communication when there is radio Authorized Service failure communication failure. centers. 011058 Note: These values can be changed on PC (except for BFT041R). Refer to SRCV02 USER MANUAL for details.
Page 9
For LED#B 1. LED#B1 2. LED#B2 007917 LED indicator / Beeper on the tool shows the following functions. Description Viewed color View and status lights up when the tool is connected to a receiver. when the tool is on the step of being connected to a blinks receiver.
Use an optional adjusting grip to adjust the NOTE: fastening torque. Insert the pin of the adjusting If the bit is not inserted deep enough into the • grip into the hole in the front of the tool. And then, sleeve, the sleeve will not return to its original turn the adjusting grip clockwise to set a greater position and the bit will not be secured.
Page 11
Only use accessory or attachment for its stated purpose. If you need any assistance for more details regarding these accessories, ask your local Makita Service Center. Makita genuine battery and charger • Adjust grip • Protector •...
Page 12
Makita Corporation Anjo, Aichi, Japan www.makita.com 884708B228...