5.3.3
Set protocol parameters
Introduction
This section covers the programming, editing, or verifying of all parameter values.
All protocol parameters are set in the edit mode. Press the EDIT key to toggle between
the first editable screen and the protocol identification screen.
Note:
Create or edit protocols
Follow the instructions below to edit the rehydration parameters, time and temperature,
and the IEF parameters, temperature, μA/Strip and number of strips as necessary on
the main screen.
Step
1
2
Ettan IPGphor 3 Operating Instructions 28-9635-51 AC
The cursor stops only in the fields that can be edited. Once the cursor is in po-
sition, press the Up or Down arrow keys to adjust the value.
Action
Select the protocol to be created or edited from the protocol identification
screen.
Position the cursor under the protocol number field using the Right and Left
arrow keys and move to the desired protocol number using the Up and
Down arrow keys.
P r o t # 1 F i l e 1
R e h y d r a t e 1 0 : 0 0 H r @ 2 0 ˚ C
I E F @ 2 0 ˚ C 5 0 µ A / S t r i p
1 S t r i p s 0 S t e p s
5.3 Perform a run from the control panel
5.3.3 Set protocol parameters
5 Operation
75