Windows 2000 Installation And Setup - Linksys 10/100 LAN Card 10/100 User Manual

Windows 2000 Installation &
Setup
Overview
After physically installing the EtherFast 10/100
LAN Card in your computer, follow these
instructions to install the network driver. The
installation procedure for the network driver will
vary slightly depending on which version of
Windows 2000 you are using, and on your cur-
rent system configuration. If at any time during
the installation you encounter problems, consult the Troubleshooting section
on page 45.
Installing the Driver in Windows 2000
After physically installing the EtherFast Card in your computer, follow these
instructions to install the network driver.
1. Start your computer if you haven't already done so, and boot
Windows 2000. Log in if you are asked to.
2. Windows will display the Found New Hardware Wizard box. Click Next.
24
Linksys EtherFast Series
N N o o t t e e : : Prior to
proceeding,
ensure that you
are operating
Windows 2000
with administrative rights. If
you log into Windows 2000
without administrative rights,
you may run into problems
during the installation.