Changing Filament - Grizzly G0923 Owner's Manual

Changing Filament

Use the "Change Filament" process from the main
menu to load or change filament. If you are print-
ing frequently, filament can remain in your printer.
However, filament absorbs humidity, so it is best
to remove it and store in a sealed container. Store
container in a cool, dry location when not in use
for an extended period of time.
To change filament:
1.
Press control dial to open main menu.
2.
Select "Change filament." Nozzle will begin
preheating, then feeder will begin to retract
filament from the print head (see Figure 35).
When process is complete, filament status
screen changes to "Insert filament and press
button to continue."
Figure 35. Unloading filament status screen.
3. Press tensioner and pull filament from feeder
(see Figure 36).
Feeder
Figure 36. Removing filament from feeder.
Model G0923 (Mfd. Since 05/20)
Filament
Tensioner
4. Remove old spool from printer and replace
with new spool.
5. Press tensioner on feeder and insert filament.
When tensioner is released, filament should
be pinched against hobbed gear (see Figure
37).
Hobbed
Gear
Figure 37. Filament installed in feeder.
6. Press control dial. Feeder will begin to push
filament into print head. Wait for process to
complete (see Figure 38).
Figure 38. Loading filament status screen.
Tensioner
-29-