Grizzly Extreme Series G0514X Owner's Manual page 28

Dust Collection
DO NOT operate this bandsaw without an
adequate dust collection system. This saw
creates substantial amounts of wood dust
while operating. Failure to use a dust col-
lection system can result in short and long-
term respiratory illness.
Recommended CFM at Dust Port: 400 CFM
Do not confuse this CFM recommendation with
the rating of the dust collector. To determine the
CFM at the dust port, you must consider these
variables: (1) CFM rating of the dust collector,
(2) hose type and length between the dust col-
lector and the machine, (3) number of branches
or wyes, and (4) amount of other open lines
throughout the system. Explaining how to cal-
culate these variables is beyond the scope of
this manual. Consult an expert or purchase a
good dust collection "how-to" book.
To connect a dust collection hose:
1.
Figure 34
2.
Note: A tight fit is necessary for
proper performance.
Figure 34.
Installing Fence
(G0514X, -X2, X3)
To install the fence:
1.
Figure 35
2.
Figure 35
Figure 35.
3.
Figure 36.
Figure 36