Honeywell NOTIFIER ID2000 Series Operating Manual page 52

ID2000 Series Operating Manual
PANEL STATUS: EVACUATE
This is the condition when the EVACUATE pushbutton
has been pressed.
The condition continues to be shown until superseded
by a higher-priority condition or until cleared by pressing
the SILENCE SOUNDERS pushbutton).
The LCD displays the message shown below:
EVACUATE
(blank) or (System Normal message)
The indications of the panel and external equipment are
as follows:
LAMP indications:
Internal sounders:
Circuits Controlled Internally:
External Devices:
The LEDs of active Control Modules (those for which the
control output is ON) will be OFF.
The LEDs of all other sensors and modules should either
give short pulses or be OFF altogether, as configured.
The LED above the EVACUATE pushbutton is ON.
A1 - 9
(date)
POWER (green):
All others
Sounder Circuits: if not substituted
by alternative devices in matrix
program, both circuits on
FIRE, FAULT relays:
depending on programmed
EVACUATE schedule some
or all Control modules may
be ON, either steady or pulsing.
997-434-000-4, Issue 4
(time)
O N
OFF
OFF
STEADY
OFF
May 2010