Set Call Back; When The Busy Terminal Becomes Idle; Cancel Call Back; Timed Queuing (Outside Line Only) - NEC UNIVERGE SV9100 DT930 User Manual

1.

Set Call Back

This feature is only available for the telephone
that is set by system data setting at initial
installation.
(1) The called party extension is busy or no answer.
(2) Press the Camp or Camp-On (35).
(3) Replace the handset.
Wait for Call Back.

When the Busy Terminal Becomes Idle

(1) The telephone, which set Call Back, is alerted by
a ringing.
When busy terminal becomes idle or the
telephone that did not answer initiates or answers
a call or accesses a feature and then becomes
idle, the telephone used to set Call Back is alerted
by ringing.
The Call Indicator Lamp flashes.
(2) Lift the handset.
The extension number that was busy/no answer
is automatically dialed.

Cancel Call Back

This feature is only available for the telephone
that is set by system data setting at initial
installation. This feature cannot be canceled
using a softkey.
(1) When the telephone is set with the Call Back
feature, the Call Back feature key lamp lights red.
(2) Press Camp-On (35).
CAMP CANCEL displays on the telephone LCD.
The Camp-On (35) lamp goes off.

Timed Queuing (Outside Line Only)

When a user originates an outgoing trunk call and the
called party is busy or does not answer, the caller can
set the Timed Queuing. When this feature is set, the
trunk seizure is repeated and the number is dialed
again after a predetermined time interval.
The feature key is set by system data setting at
initial installation.
For details, contact the system administrator.
(1) Press the Speaker key.
You receive a dial tone.
The Speaker key lamp lights red.
(2) Dial the Outside Line access code.
(3) Dial desired number.
You receive a busy tone or a ring no answer from
distant end.
(4) Press Camp or Camp-On (35).
(5) Leave the speaker on.
The desired number automatically redials.
(6) Start the conversation with the called party.
A busy tone is sent to the calling party when
the call is made to the extension that is in
Timed Queue mode.

Make/Answer a Call with Call in Progress

This feature allows you to put to hold a call in progress
by pressing the Call Hold feature key. This line can then
be used for originating another call or answering
another incoming call. After finishing another call and
replacing the handset, the original held call rings back.
71