Mode Button And Status Indicators - Honeywell IH25 User Manual

MODE Button and Status Indicators

Press the MODE button to light on the current mode light.
Release the button within 3 seconds, the mode light is off.
Press and hold the MODE button for at least 3 seconds to
switch between 1D/2D and RFID mode and the current mode
light is on. Release the button, the current mode light is off.
Solid amber: Charging
Solid green: Fully charged
Red flash/ Green and amber flash alternately: Charge error
Solid red: Battery low warning (<20% capacity remaining.)
Blue slow flash: Bluetooth disconnected (two beeps when
disconnect from PDA)
Solid blue: Bluetooth connected (one beep when
connected successfully)
8 IH25 Bluetooth UHF RFID Reader