Installation Methods; General Rack Installation Guidelines - Cisco ASR 1002-X Overview And Installation

Installation Methods

Power Cord Item Number
CAB-ACI-RA
CAB-ACR-RA
CAB-ACS-RA
CAB-ACU-RA
CAB-IND-RA
CAB-JPN-RA
Installation Methods
The Cisco ASR 1002-X Router is designed for a standalone, 2-rail 19-inch rack mount (front rail only), 4-rail
19-inch rack mount (front and rear rail).
Although rack-mounting is the preferred method of installation for the Cisco ASR 1002-X Router, you can
mount the chassis on an equipment shelf or tabletop.
Note The Cisco ASR 1002-X Router is usually shipped fully loaded. However, you can remove components such
as the power supplies, from the chassis to make the chassis lighter for your rack installation.
Warning This warning symbol means danger. You are in a situation that could cause bodily injury. Before you work
on any equipment, be aware of the hazards involved with electrical circuitry and be familiar with standard
practices for preventing accidents. Use the statement number provided at the end of each warning to locate
its translation in the translated safety warnings that accompanied this device. Statement 1071
Warning Before you install, operate, or service the system, read the Regulatory Compliance and Safety Information
for Cisco ASR 1000 Series Aggregation Services Routers publication. This document provides important
safety information you should know before working with the system. Statement 200
Note Proceed with the installation only after you unpack your chassis and read all the site requirements for your
new equipment. Proceed with the installation.

General Rack Installation Guidelines

When planning your rack installation, consider the following guidelines:
Cisco ASR 1002-X Router Overview and Installation
12
Description
Power Cord, Italy, Right Angle
Power Cord, Argentina, Right Angle
Power Cord, Switzerland, Right Angle
Power Cord, UK, Right Angle
Power Cord, India, Right Angle
Power Cord, Japan, Right Angle
Cisco ASR 1002-X Router Overview and Installation