Advertisement
Available languages
Available languages
Indicator LEDs
Description
Normal
Charging (battery test not possible while charging)
Mains off, battery not connected or charger fault
Battery test
Battery fault
Light source test
Light source fault
Battery fault and light source fault
LED status explanation
On
Off
The ImperLED E is a self-contained luminaire with selftest function.
It can be configured as maintained or non-maintained.
Selftest functions
Every 15 days the luminaire will perform an emergency operation test. This will light the light source
for approximately 3 seconds. The red indicator LED will flash during this test sequence.
Every 6 months the luminaire will perform a battery condition test. The test will last for 60 minutes. The
light source will be lit and the yellow indicator LED will flash during this test sequence.
Note: When using DALI or Wireless communication, the frequencies and schedules for tests will
instead be determined by the connected PC software.
Manual test functions and fault reset
Manual tests and fault reset operations must
be performed using the A-1900 card
(not included and available on request).
Manual tests can only be performed if both mains and
battery are connected.
Light source test
By activating the magnetic contact briefly (less than 5 seconds) an emergency operation test is
performed. The light source will be lit for approximately 3 seconds, the red indicator LED will flash
during this test sequence. The test will start only if the battery has enough charge.
Battery test
By activating the magnetic contact for a period lasting between 5 and 10 seconds, a battery condition
test is performed. This test will last for 60 minutes and can only be performed when the battery is fully
charged (steady green indicator LED). The light source will be lit and the yellow indicator LED will
flash during this test sequence.
Fault reset
Activate the magnetic contact for a period lasting between 10 and 15 seconds to delete all indicated
errors. Then the luminaire enters regular operation mode.
Honeywell Life Safety AS, Po. Box 3514, N-3007 Drammen, Norway
Flashing
Technical description
ImperLED E Combi ST LED 230V 1h wPict 10y
Part no.:
Lumen output, normal:
Lumen output, emergency:
Weight:
Maximum power consumption:
Operation voltage:
Emergency mode duration:
Battery:
Charge current:
Max. discharge current:
Min. discharge current:
Battery protection:
Charging time:
Ambient temperature range:
Relative humidity:
Classification:
Technical lifetime (light source):
IP rating
Expected battery lifetime 10 years
At the end of their useful life the
packaging, product and batteries
should be disposed of via a
suitable recycling centre. Do not
dispose of with your normal
household waste. Do not burn.
http://www.hls-nordic.com
GB
290406.10
250 lm
350 lm
880 g
5.4W / 5.6VA
220-240V AC / 50-60Hz
Minimum 1 hour
4.8V / 2Ah Li
Ti
O
4
3
12
200-210 mA/CC until 5.6V
910mA
425mA
Overcharge and full discharge
16 hours
-25 to +40 °C
Up to 95%
EN 60598-1, EN 60598-2-22, EN 55015,
EN 61547, EN 61000-3-2, EN 61000-3-3
> 100.000 hours
IP 65
Advertisement
