Makita DPB181 Technical Information page 5

R
epair
[3] DISASSEMBLY/ASSEMBLY
[3] -2. DC Motor (cont.)
DISASSEMBLING
(2) Disassemble the DC Motor as drawn in Fig. 5.
Fig. 5
1. Remove the following 4x18 Tapping screws.
A 6 pcs. of the screws fastening
Handle section to Frame
B 4 pcs. of the screws fastening
Motor housing to Frame
B
3. Separate Motor housing L by unscrewing
four 4x18 Tapping screws.
5. Pull out DC Motor from Gear housing section.
2. Remove seven 4x18 Tapping screws.
And then separate Handle R from Handle L.
A
Motor housing
Note in disassembling:
Do not pull out Motor housing from Handle L forcibly
because they are connected by Lead wires.
4. Separate DC Motor together with Gear housing
section from Motor housing R by disconnecting
Receptacles from DC Motor.
DC Motor
Gear housing cover
Gear housing
Handle R
Handle L
Receptacles
DC Motor
Note in disassembling:
If Ball bearing of DC Motor remains
in the Gear housing cover, remove
the ball bearing as drawn in Fig. 6 in
the next page.
Ball bearing
P 5/ 18