Advertisement
9. Remove drain hook from drain tube.
10. Remove ground wire from evaporator.
11. Install 18" foam air deflector (from kit) behind
bottom rear pass of evaporator. Make certain to
fit completely between end brackets and foil side
of air deflector is facing evaporator. Use pieces
of the 6" aluminum tape supplied in kit to hold air
deflector in place.
18" Foam Air Deflector
Tape
Air Deflector
Make Certain
to Fit Completely
Between the End
Brackets
Bottom
Rear Pass
12. Make certain Styrofoam blocks are dry and apply
a 4 1/2" foam strip (2 in kit) to the top of each
Styrofoam block and a 6 1/4" foam strip
(2 in kit) to the bottom of each Styrofoam block as
shown in the illustration.
Self-Adhesive
4 1/2" Foam Strips
(side and back only)
13. Reinstall Styrofoam blocks.
14. Reinstall drain hook.
Styrofoam
Blocks
Self-Adhesive
6 1/4" Foam Strips
(side and back only)
15. Place 19" metal bracket (from kit) at top of evapo-
rator as shown in the illustration and attach
evaporator ground wire to metal bracket. Install
two 1/2" self-drilling screws (from kit) as shown.
16. Install the 3/4" x 1 1/2" x 3 1/2" foam block
(from kit) at left top of evaporator as shown
in the illustration.
Foam Block
107-22F
Foam
Block
Styrofoam Blocks
Metal Bracket
Assembly
Metal Bracket
Assembly
Foam Deflector
Styrofoam Blocks
Advertisement
