Advertisement
Installation Instructions
1. Horizontal tower
2. Vertical tower
3. Two self-adhesive foam strips (1/2" x 1/2" x 4 1/2"),
goes on top edge of left and right Styrofoam™
blocks.
4. Two self-adhesive foam strips (1/2" x 1/2" x 6 1/4"),
goes on bottom edge of left and right Styrofoam
blocks.
5. Air deflector (1 1/2" x 1/4" x 18" foam strip with
aluminum wrap), goes between rear of
evaporator and liner.
6. Aluminum tape (6" by 2" wide), to hold air deflec-
tor in place.
DISCONNECT POWER TO
THE REFRIGERATOR BEFORE
BEGINNING KIT INSTALLATION
Before you begin...
Read these instructions completely and carefully for
the correct installation of kit WR49X10044.
1. Remove icemaker or ice tray.
2. Remove light lens.
Note: If unit is equipped
with a light bulb, discard
translucent lens. Save
lens if no light bulb
is present.
3. Remove horizontal air tower.
Horizontal Tower
Note: Remove light socket from tower (if applicable)
and discard horizontal tower.
162D3539P233
Parts Included in Kit:
7. Metal bracket assembly (19" metal bracket with
8. Two screws (1/2" long)
9. Foam block (3/4" x 1 1/2" x 3 1/2"), to go at top of
10. Self-adhesives foam strip (1/2" x 1/2" x 25 1/2"), to
11. Two plastic wire ties
12. Electronic Main Board
13. Freezer light lens cover
14. Icemaker grille.
4. Remove and discard
vertical air tower.
Lense
5. Remove louvered icemaker grille in evaporator
cover and discard. If equipped with icemaker,
remove scoop and discard.
6. Disconnect icemaker receptacle from evaporator
cover.
7. Remove evaporator cover
(note 2 clips in fan housing
and ground wire). Defrost
evaporator and wipe off
moisture if necessary.
Light
8. Remove Styrofoam block
Socket
from each side of
evaporator.
WR49X10044 Kit
foam strip attached), to be screwed to top of left
and right evaporator end brackets.
left corner of evaporator.
go on the front surface of the metal bracket.
Styrofoam Blocks
Vertical Tower
WR00X2134
Advertisement
