Honeywell Bendix/King KX 165A Maintenance Manual page 88

BENDIX/KING
E. Covers and Shields
Inspect covers and shields for punctures, deep dents, and badly worn surfac-
es. Also, check for damaged fastener devices, corrosion and damage to fin-
ish.
G. Insulators
Inspect insulators for evidence of damage, such as broken or chipped edges,
burned areas, and presence of foreign matter.
H. Jacks
Inspect all jacks for corrosion, rust, deformations, loose or broken parts,
cracked insulation, bad contacts, or other irregularities.
I. Potentiometers
Inspect all potentiometers for evidence of damage or loose terminals, cracked
insulation or other irregularities.
K. Resistors, Fixed
Inspect the fixed resistors for cracked, broken, blistered, or charred bodies
and loose, broken, or improperly soldered connections.
L. RF Coils
Inspect all RF coils for broken leads, loose mountings, and loose, improperly
soldered, or broken terminal connections. Check for crushed, scratched, cut
or charred windings. Inspect the windings, leads, terminals and connections
for corrosion or physical damage. Check for physical damage to forms and
tuning slug adjustment screws.
M. Terminal Connections Soldered
1. Inspect for cold-soldered or resin joints. These joints present a porous
or dull, rough appearance. Check for strength of bond using the points
of a tool.
2. Examine the terminals for excess solder, protrusions from the joint, piec-
es adhering to adjacent insulation, and particles lodged between joints,
conductors, or other components.
3. Inspect for insufficient solder and unsoldered strands of wire protruding
from conductor at the terminal. Check for insulation that is stripped back
too far from the terminal.
4. Inspect for corrosion at the terminal.
N. Transformers
1. Inspect for signs of excessive heating, physical damage to case,
cracked or broken insulation, and other abnormal conditions.
2. Inspect for corroded, poorly soldered, or loose connecting leads or ter-
minals.
Page 5-40 15610M00.RCD
KX 165A
Rev 0, Jun/2000