Filling The Dispensers - Siemens WM T Series Instruction Manual And Installation Instructions

Check whether the preset basic
dosages follow the manufacturer's
recommendations in terms of:
A 4.5 kg load
■
For liquid detergent – the normal
■
degree of soiling and the relevant
water hardness
For fabric softener – the medium
■
softness
Refer to the packaging label on your
liquid detergent/fabric softener or ask
the manufacturer directly for this
information.
Below is an example of detergent
dosages on a packaging label:
For standard load
4 - 5 kg
Water soft/
hardness medium
hard/
very
hard
In this example, a basic dosage of 55 ml must be
set for a medium water hardness.
If necessary, adjust the basic dosages
to the recommended load for the liquid
detergent/care product you are using,
the water hardness and/or the degree
of soiling.
Adjusting the basic dosage
Press and hold ‰ i-Dos and/or
1.
 i-Dos for approx. 3 seconds.
The basic dosage setting will be
displayed.
Change the setting using: ˜/~
2.
To exit setting mode, press and hold
3.
‰ i-Dos and/or  i-Dos for
approx. 3 seconds or wait approx.
10 seconds.
Level of soiling
light normal heavy
40 ml 55 ml 80 ml
55 ml 80 ml 105 ml
Intelligent dosing system
Notes
The changes are applied to all
■
programmes in which dosing is
possible.
The changes are saved until the next
■
time they are changed and are
retained even after the appliance has
been switched off.

Filling the dispensers

Notes
See the instructions in chapter
■
~ "Before setting up i-Dos"
on page 37
If ¨ or M flashes, fill the relevant
■
dispenser. ~ Page 37
Fill the dispensers as follows:
Pull out the detergent drawer.
1.
Open the dispenser lids.
2.
Pour liquid detergent and fabric
3.
softener into the relevant dispensers.
Notes
– Do not fill the dispensers above
the max. mark.
en
39