Table of Contents
Advertisement
SWITCHING ON AND OFF - Fig. J
CAUTION:
FOR FLOOR USE ONLY;
DO NOT USE THE UNIT UPSIDE DOWN.
NOTICE:
When the steam mop is first
turned on the water reservoir will glow red.
reservoir will glow blue. It takes approximately
15 seconds for the steam mop to heat up.
NOTICE:
Never leave the steam mop in one spot on any surface for any period of time.
Always place the steam mop on the resting mat (7) with the handle tube (4) in the upright
position when stationary and make sure the steam mop is turned off when not in use.
NOTICE:
Always empty the steam mop
after use.
TM
SmartSelect
Dial - Fig. K
The steam mop is equipped with a
TM
dial (2) which shows various
hard floor surface cleaning applications.
They are used to select the correct operating
mode for your particular hard floor surface.
WARNING:
Do not use on any
unsealed hard floor surfaces. Additionally, on
surfaces that have been treated with wax or
some no wax floors, the sheen may be
removed by the heat and steam action. It is always recommended to test an isolated
area of the surface to be cleaned before proceeding. We also recommend that you
check the use and care instructions from the floor manufacturer.
TM
Using the SmartSelect
The steam mop will select the correct volume of steam required for your particular
cleaning operation.
NOTICE:
The SmartSelect
on will recall the previously used setting.
STEAM BURST BUTTON - Fig. K
The steam burst button is built in feature that aides in the removal of stubborn floor marks or
stuck on grime.
NOTICE:
The steam burst will last for 10 seconds then the steam mop will return to
the chosen setting.
NOTICE:
This unit will kill 99.9% of bacteria and germs when used in accordance with
this manual and with the micro fiber pad fitted and a continuous run time of 90 seconds
OPERATION
J
K
dial (2), choose from one of the following applications:
TM
Dial
7
Advertisement
Table of Contents
