Table of Contents
Advertisement
THE LIFT AND REACH HEAD - Fig. G
tight corners and narrow gaps.
CAUTION:
Always wear suitable shoes
your steam mop. Do not wear slippers or
open-toed footwear.
TO ACCESS THE LIFT AND
REACH HEAD:
Return the handle to the upright position and
Place the steam mop on the resting mat and wait until it cools down. (approximately five minutes)
Place the front of your shoe onto the steam head removal tab (15) and press down gently.
cleaning pad (9). You are now ready to steam clean and sanitize your floor.
TO RE-FIT THE LIFT AND REACH HEAD:
five minutes)
and press down firmly.
Ensure it is locked into place by gently pulling upwards on the handle.
NOTICE:
Always place the steam mop on the resting mat (7) with the handle tube (4) in the
upright position when stationary and make sure the steam mop is turned off when not in use.
FILLING THE WATER TANK - Fig. H, I
WARNING:
Your water tank has a
15.6oz capacity. Do not over fill the tank.
NOTICE:
The water tank is conveniently
removable for easier use.
NOTICE:
Fill the water tank with regular tap water.
NOTICE:
In areas of very hard water, the
use of de-ionized water is recommended.
Ensure that the appliance is switched off
and the power cord is disconnected from the
power supply.
Place the steam mop on the resting mat (7)
with the handle tube (4) in the upright position.
Remove the water tank (3) by pulling it
upwards.
Fill the water tank with water.
Re-install the water tank onto the steam
mop body (11).
NOTICE:
Always empty the steam mop
after use.
G
H
I
6
Advertisement
Table of Contents
