350xg series 10g stackable managed switches (17 pages)
Summary of Contents for Cisco SGE2000P
Page 1
Accessing the Setup Page for SGE2000P Objective The set up page allows the user to adjust basic settings for the SGE2000P device such as port and system configuration as well as the current stacking mode. This document shows the user how to access the setup page for SGE2000P...
Page 2
Step 4. Set the serial port settings as follows •Bits per second: 115200 •Data bits: 8 •Parity: None •Stop bits: 1 •Flow control: None Step 5. On the login screen type admin for the username and leave the password blank.
Page 3
Step 6. Go to the System Mode tab for the device. By default the switch is set to Layer 3. You will need to set it to Layer 2 so you can use static IP address for the device.
Page 4
Step 7. Save the settings and then go back to the System Configuration tab. Step 8. Go to the IP address settings and then set the device to static IP address. After...
Page 5
assigning the static IP address for the switch, save the settings. Step 9. You may access the setup page for the switch now using your web browser. On your...
Page 6
browser type http://192.168.1.254 and it will ask for the username and password. The default username is admin and leave the password blank. Note: If you are using DHCP address for the switch, you may still be able to access the device through your browser.