Start/Pause ( ) And Add Clothes ( ) Touchpad; Before First Use - Zanussi ZWH71046 User Manual

Enabling/Disabling End-Of-Wash Buzzer
This setting permits you to either enable
or disable the buzzer at the end of the
program. As an example, you might wish to
disable this buzzer when you start a wash
when going to bed, so that when the wash
finished approximately 1 hour later, it will not
disturb you through the night.
Error warning beeps such as critical
faults are not disabled.
To disable the buzzer sound, press "Easy Iron
( ) and Prewash (
same time for 3 seconds, and listen for
"BEEP, BEEP".
To return to default configuration press these
2 touchpads at the same time for 3 seconds,
and listen for "BEEP".
3.7 Start/Pause (
Add Clothes (
This touchpad has 2 functions:
● Start/Pause (
After you have selected the desired program
and options, press this touchpad to start the
machine. The Start/Pause pilot light will stop
flashing and remain lit until the water level is
above the bottom edge of the door then pilot
light goes OFF. If you have selected a
"Delay End" option, the countdown will
begin and will be shown in the display.
4.

BEFORE FIRST USE

NOTE
During installation or before first use you may
observe some water in the machine. This is a
residual water left in the machine after a full
functional test in the factory to ensure the
machine is delivered to customers in perfect
working order and is no cause for concern.
1. Ensure that the electrical and water
connections comply with the installation
instructions.
Put 2 litres of water in the detergent compart-
2.
ment for washing phase. This activates the
drain system.
)" touchpads at the
) and
) Touchpad
):
To interrupt a program which is
running, press this touchpad to pause
the machine, the Start/Pause pilot
light flashes.
To restart the program from the point
at which it was interrupted, press this
touchpad again, the Start/Pause pilot
light will stop flashing.
● Add Clothes (
You can only add clothes if
"Start/Pause" pilot light is lit.
While running a program, you may add
clothes by:
-
Pressing the "Start/Pause" touchpad
to pause the program.
-
Wait for the machine to come to a
complete stop before opening the
door.
-
Add clothing and close the door.
-
Resume the program by pressing
"Start/Pause" touchpad again.
You cannot open the door if
the water inside the machine
drum are hot, the door
remains locked for your
safety. Although the LED
light still remain lit.
3. Select a Cottons cycle at 90 °C,
without any laundry in the machine, to
remove any manufacturing residue
from the drum and tub then start the
machine.
ENGLISH 13
):