Honeywell Miller Revolution Harness Manual page 5

DONNING THE REVOLUTION WITHOUT BELT
B . Donning the Revolution without belt
B .1
B .4
B.1 Hold harness by back D-ring. Shake harness to allow all straps to fall in place.B.2 If leg or chest straps are
buckled, release straps and unbuckle at this time.
B.3 Slip straps over shoulder so D-ring is located in the middle of the back between shoulder blades.
B.4 Pull buckle portion of leg strap between legs and connect to opposite end of leg strap. Repeat with second
leg strap.
B.5 Connect chest strap. The shoulder strap retainer (chest strap) must be positioned in the mid-chest area 15 to 20
cm below the trachea but not below the sternum.Fasten securely to keep shoulder straps taut.
B.6 After all straps have been buckled, thighten webbing so that harness fits snug, but allows full range of
movement. To maximize comfort, be sure to adjust the harness so that the PivotLink centers are at waist level.
B.7 Front anchorage loops should be level with the sternum. When using this anchorage point, the intermediate
attachment should be connected to both loops.
B.8 To remove harness, release quick connect or tongue buckles.
B .2
B .5
B .3
B .6
5