Removing Sfp Modules - Cisco ASR-920-8S4Z-PD Hardware Installation Manual

Removing SFP Modules

Step 5
Insert the cable connector into the SFP module:
• For fiber-optic SFP modules, insert the LC cable into the SFP module.
• For copper 1000BASE-T SFP modules, insert the RJ-45 cable connector into the SFP module.
Removing SFP Modules
To remove an SFP module from a module receptacle, follow these steps:
Procedure
Step 1 Attach an ESD-preventive wrist strap to your wrist and to a bare metal surface on the chassis.
Step 2 Disconnect the cable from the SFP module, and insert a dust plug into the cable end.
Tip
Step 3 Unlock and remove the SFP module, as shown in the following figure.
If the module has a bale-clasp latch, pull the bale out and down to eject the module. If the bale-clasp latch is
obstructed and you cannot use your index finger to open it, use a small, flat-blade screwdriver or other long,
narrow instrument to open the bale-clasp latch.
Cisco ASR 920-10SZ-PD and Cisco ASR-920-8S4Z-PD Aggregation Services Router Hardware Installation Guide
44
For reattachment, note which cable connector plug is send (TX) and which is receive (RX).
Installing the Cisco ASR 920-10SZ-PD and Cisco ASR-920-8S4Z-PD Routers