Eaton Sure-Lites XR6C-LED Installation Instructions

IB505020EN
Installation Instructions for the Sure-Lites XR6C-LED Emergency Light
WARNING
Risk of Fire/Electric Shock
If not qualified, consult an electrician.

Important Safeguards

WHEN USING ELECTRICAL EQUIPMENT, BASIC SAFETY
PRECAUTIONS SHOULD ALWAYS BE OBSERVED INCLUDING
THE FOLLOWING.
1. READ AND FOLLOW ALL SAFETY INSTRUCTIONS
2. Do not use outdoors.
3. Do not use in hazardous locations, or near gas or electric
heaters.
4. Do not let power supply cords touch hot surfaces.
5. Use caution when servicing batteries. Battery acid can
cause burns to skin and eyes. If acid is spilled on skin or in
eyes, flush acid with fresh water and contact a physician
immediately.
6. Do not use this equipment for other than the intended use.
7. Installation is to be performed only by qualified personnel.
8. Install in accordance with National Electric Code and local
regulatory agency requirements.
9. The use of accessory equipment not recommended by the
manufacturer may cause an unsafe condition.
10. Equipment should be mounted in locations and at heights
where it will not readily be subjected to tampering by
unauthorized personnel.
11. SAVE THESE INSTRUCTIONS
MAX MOUNTING HEIGHT: 27.6 ft.
INSTALLATION
1. De-energize the circuit at the junction box (J-box) where
the emergency light is to be installed.
2. Open the emergency light by inserting a screwdriver in the
two slots on either side of the unit, then tipping the cover
up off of the backplate (See Fig. 1).
3. To mount to a junction box - Knock out the appropriate
mounting pattern and the wire pass hole in the backplate
to fit the J-box being used.
4. To mount using conduit, mount the backplate to the wall
in the desired location. Attach a conduit hub to which
049-276
Risk of Electric Shock
Disconnect power at fuse or circuit breaker before
installing or servicing.
NOTE: A fourth conduit mount location is available on the
5. Once the backplate is secured, the housing can be held in
6. Connect the incoming wires to the fixture's power supply
7. Hook the top of the housing to the top of the backplate,
8. Remove the EZ key battery disconnect.
9. Energize AC supply. The test button should illuminate, and
10. Adjust the heads as needed.
11. If the fixture is to be powered down for an extended
Figure 1
SURE-LITES
WARNING
ever of the three conduit mount points on the backplate is
most convenient. (see Fig. 2) Remove the corresponding
U shaped cover from the housing by wiggling it back and
forth until it breaks free. (see Fig. 3)
bottom surface of the housing, but it can only be used with
flex conduit.
place during installation using the EZ Hang feature.
(see Fig. 2)
wires using the wire nuts provided. Connect ground to the
green ground wires. Connect the white wire to neutral. If
using 120V, connect the black wire to the hot lead. If using
277V, connect the orange wire to the hot lead. Cap the
unused lead (see Schematic).
and swing the housing down until it snaps into place.
(see Fig. 1)
LED heads will illuminate briefly when the test button is
pushed.
period after initial installation, replace the EZ Key. This
will prevent the battery from discharging when AC power
is removed. However, it will also prevent the battery
from charging when AC power is restored, so it must be
removed once the unit is ready for regular operation.
Insert screwdriver
in slots in both
sides while gently
lifting the housing to
release snaps and
open housing.
INS #