Advertisement
4.6. Placing heat-conductive foil
conductive foil
Remove protective foils from both sides of heat
Remove protective foils from both sides of heat-conductive foil. Place one on each transistor
(pict.7). After that, close your gearbox
(pict.7). After that, close your gearbox and check, if it can be closed without any problem. If not,
you can remove heat-conductive foils and leave unit without t
Pict.7: Removing protective foils from
Removing protective foils from heat-conductive foils and their placing
4.7. Replica completion
Assemble the rest of your gearbox in standard way and insert it into your replica. You can now test
Assemble the rest of your gearbox in standard way and insert it into your replica. You can now test
Assemble the rest of your gearbox in standard way and insert it into your replica. You can now test
your PSJ-M3 and set your prefered fire mode.
and set your prefered fire mode.
5. Fire modes
5.1. Preset modes
Selector on semi:
1.
Semi
2.
Semi
3.
Semi
4.
Semi
5.
Burst only
6.
Burst only
5.2. Unit programming
a)
For programming, connect battery and within 5 seconds press and hold trigger for another
For programming, connect battery and within 5 seconds press and hold trigger for another
For programming, connect battery and within 5 seconds press and hold trigger for another
5 seconds. Entering is confirmed by motor vibrating twice.
5 seconds. Entering is confirmed by motor vibrating twice.
b)
Next, choose category from menu by pressing trigger as many times as is the number you
Next, choose category from menu by pressing trigger as many times as is the number you
Next, choose category from menu by pressing trigger as many times as is the number you
wish to select.
c)
After that, press and hold trigger for 5 second to enter submenu. Your choise is confirmed
After that, press and hold trigger for 5 second to enter submenu. Your choise is confirmed
After that, press and hold trigger for 5 second to enter submenu. Your choise is confirmed
by motor vibrating as many times as is selected number.
by motor vibrating as many times as is selected number.
d)
When changing fire mode (menu 3), every trigger press is followed by motor vibrating as
When changing fire mode (menu 3), every trigger press is followed by motor vibrating as
When changing fire mode (menu 3), every trigger press is followed by motor vibrating as
many times as is selected number of fire mode. Submenu goes in cycle, after number 6
follows number 1.
e)
When you are done with setting value, press and hold trigger for 5 seconds to save your
When you are done with setting value, press and hold trigger for 5 seconds to save your
When you are done with setting value, press and hold trigger for 5 seconds to save your
settings. Double vibration confirms successful saving and exiting programming function.
settings. Double vibration confirms successful saving and exiting programming
settings. Double vibration confirms successful saving and exiting programming
and check, if it can be closed without any problem. If not,
conductive foils and leave unit without them.
Fire modes and programming
Selector on auto:
Selector on auto:
Burst / Auto
Burst / Auto
Auto
Semi
Burst only
Burst only
Auto
Burst / Auto
Burst / Auto
is selected number of fire mode. Submenu goes in cycle, after number 6
is selected number of fire mode. Submenu goes in cycle, after number 6
conductive foil. Place one on each transistor
their placing, gearbox check
programming
Advertisement
