Related Manuals for Grizzly PSJ-M3 GEN2
Summary of Contents for Grizzly PSJ-M3 GEN2
- Page 2 So it corresponds ind new fire modes, correct instalation indication and many more new functions. So it corresponds with second generation of GRIZZLY processor units. with second generation of GRIZZLY processor units.
- Page 3 2.5. Active break • stops motor immediately with piston in default position and sping loose stops motor immediately with piston in default position and sping loose stops motor immediately with piston in default position and sping loose • increases lifetime of piston, sping and many other parts piston, sping and many other parts •...
- Page 4 4.1. Preparation For PSJ-M3 installation, take gearbox out of your replica, open it and remove all of its content (pict.1). Pict.1: Gearbox with all of its content removed 4.2. PSJ-M3 mounting Insert your unit into gearbox, wires first (pict.2). If it does not fit properly, you can adjust it by rasping.
- Page 5 4.3. Selector plate Insert prepared selector plate into position of your gearbox (pict.3). Check if the magnet is right above the probe, when selector is set on semi. If not, adjust magnet on selector plate. If you wish to modify your own selector plate, you need to remove part of plate where it meets cut-off lever. Finally, stick the magnet on selector, so it is above the probe when selector is set on semi (pict.3).
- Page 6 Pict.5: Cut-off lever movement, LED indication of proper function 4.5. Trigger prepartion Insert trigger into your gearbox and check if it goes smoothly. If not, adjust your trigger. Set the trigger to position, where you want your replica to fire and mark the center of the probe. If you wish your trigger to be more sensitive, use rectangular magnet and place it the way, that it is in contact with probe until trigger fully (pict.7).
- Page 7 4.6. Placing heat-conductive foil conductive foil Remove protective foils from both sides of heat Remove protective foils from both sides of heat-conductive foil. Place one on each transistor conductive foil. Place one on each transistor (pict.7). After that, close your gearbox (pict.7).
- Page 8 Category Value (choice confirmed by vibrating in (after you select value, confirm it by holding trigger for 5s) count of selected number) 1) Burst setting Number of trigger presses = number of shots on burst (default = 3 shots) 2) Battery check setting 1) Li-pol, Li-on (default) 2) Li-Fe 3) Off (recommended for NiMH, NiCD)
- Page 9 6. Troubleshooting Troubleshooting Your PSJ-M3 is not working correctly? Check, where the problem could be: is not working correctly? Check, where the problem could be: 6.1. Replica not working at all. all. • Check if the battery is connected and charged properly. Also check that all wires are Check if the battery is connected and charged properly.