Trouble Shooting; Symptoms And Solutions - Casio D'Z IMAGE DERMOCAMERA DZ-D100 User Manual

Table of Contents

Advertisement

Trouble shooting

Symptoms and solutions

Symptoms
Power Supply
The camera won't
switch on.
The camera
switched itself off
for no reason.
The camera won't
switch off. Nothing
happens when I
press the buttons.
Charging
The operation
check indicator
does not light
orange and I can't
charge the
camera battery.
Photography
Pressing the
shutter button
doesn't take
pictures.
I'm using Auto
Focus but I still
can't get the
image in focus.
The subjects in
photographed
images are
blurred.
Probable cause and solution
1) The battery may be loaded the wrong way round (page 11).
2) The battery may be fully discharged. If so, recharge the battery
(page 12). If the battery immediately runs even so, the battery
has reached the end of its service life. Purchase a new CASIO
lithium-ion battery (DNP-100M) (sold separately).
1) The Auto Power Off function may have been triggered (page
15). Switch the camera back on.
2) The battery may be fully discharged. If so, recharge the battery
(page 12).
3) Protective action may have been triggered because the
camera exceeded a set temperature. Leave the camera
switched off for a while until it cools down before using it again.
Briefly remove the battery from the camera and then reload the
battery.
1) Connect or disconnect the cable for the AC adapter for camera
charging connected to the camera.
2) Briefly remove the battery from the camera and then reload the
battery (page 12).
3) If reconnecting the AC adapter for camera charging or
reloading the battery does not enable charging, the battery may
be damaged due to an electrostatic discharge or similar event.
Replace the battery.
1) If the camera is in playback mode, press [p] or the shutter
button to switch to photography mode.
2) If "Memory Full" is displayed, transfer some image to your
computer and then delete images you no longer need on the
camera. Otherwise, load another memory card.
1) If the lens is dirty, wipe it clean.
2) Align the center of the focusing frame with the subject.
The image may not be focused. Align the focusing frame over the
subject you want in focus and then take the shot.
76
Appendix

Advertisement

Table of Contents
loading

Table of Contents