Table of Contents
Advertisement
Replacing the battery
1.
Press [
] (Power) to switch
the camera off and then open
the battery cover.
2.
Remove the battery and insert
a new battery.
3.
Close the battery cover.
IMPORTANT!
• When you have pressed [
battery while the operation check indicator (page 7) is flashing green. Doing so
may cause data to be deleted or corrupted.
Charging
There are two ways to charge the battery, as outlined below.
Charging using the AC adapter for camera charging (AD-M50300A)
Charging using the Battery Charger Set (DCS-100M (sold separately))
. Charging using the AC adapter for camera charging
This method charges the battery while it is in the camera.
With the camera switched off, connect the cable in the sequence shown as
Charging time: Approx. 4 hours 30 minutes
DC IN
USB
HDMI OUT
• When disconnecting the adapter from the camera, always disconnect the camera
end of the cable (
] (Power) to switch the camera off, do not remove the
Cable
in the above diagram) first.
Operation check indicator
Orange: Charging
Off: Charging completed
12
Stopper
,
AC adapter
Introduction (Basic Operation)
.
Advertisement
Table of Contents
