Honeywell LKPES8M-EN Installation Instructions

Siren output
Audio output
System armed LED
(LED1)
Intruder alarm LED
(LED4)

3 x
(CR123A)
3
4
Total set arming key
Product description
Battery Replacement
Tag reader: identification area
SOS keys
System fault LED
(LED2)
Tamper alarm LED
(LED3)
Partial set arming key
Place one battery in each one of the
3 battery holders (read carefully the
battery replacement instructions on
page 1 before)
BATTERY REMOVAL AND HANDLING SAFETY
WARNING Risk of fire, explosion and burns, do not
recharge, disassemble, heat above 100° C, or
incinerate the battery. While the battery can normally
be safely removed by hand, care should be used to
ensure that the battery terminals are not shorted, nor
the battery damaged, during the removal process.
Dispose of depleted batteries by complying with
applicable national and local regulations. In the event
of the battery being damaged, use personal
protective equipment to remove it immediately, and
dispose of it in a safe manner (refer to the battery
manufacturer's specifications for such situations).
For Switzerland, Annex 2.15 of SR 814.81 applies to
the battery included with this product.
Mounting holes
Mounting
- 1 -
TAG
2
© 2010 Honeywell International, Inc.