Connection And Control Using Rtsp - Sony Vision Exchange PEQ-C100 System Integration & Services Manual

Main Unit/Pod
Set the following SDP (Session Description Protocol) in the Wowza Streaming Engine.
For details about configuration, refer to the instructions for the Wowza Streaming Engine.
The unit does not feature a function for sending SDP.
v=0
s=Vision Exchange Streaming Output
i=Vision Exchange Streaming Output
o=- 0 0 IN IP4 XXX.XXX.XXX.XXX
c=IN IP4 XXX.XXX.XXX.XXX
m=video 5004 RTP/AVP 105
a=rtpmap:105 H264/90000
m=audio 5006 RTP/AVP 98
a=rtpmap:98 mpeg4-generic/48000/2
a=fmtp:98
mode=AAC-hbr;profile-level-id=1;object=2;streamType=5;sizelength=13;indexlength
=3;indexdeltalength=3;config=1190
a=ptime:20
Notes
Enter the IP address of the Wowza Streaming Engine in XXX.XXX.XXX.XXX.

The 5004 in "m=video 5004 RTP/AVP 105" is the port number of the video set on the main

unit.
The 5006 in "m=audio 5006 RTP/AVP 98" is the port number of the audio set on the main

unit.

Connection and control using RTSP

To enable RTSP connections, on the [Setting] screen – [Streaming Output] page, place a check
mark in [Enable RTSP Connection].
Also, specify the following streaming output URI in the application that will receive the stream.
Specify settings using the configuration method of the application being used.
rtsp://host_name:port_number/media/video1
Enter the IP address of the main unit acting as the streaming output source for host_name.
Layer 2 switch
41
Wowza Streaming
Engine
Lecture capture device