Setting Dme Wipe Modifiers - Sony XVS-9000 User Manual

Parameter group [2/2]
No. Parameter Adjustment
1 Side H Size X Side H horizontal scaling factor
2 Side H Size Y Side H vertical scaling factor
3 Height Height of brick
4 Side H Side H horizontal center position
Center X
5 Side H Side H vertical center position
Center Y
a) Common with the [Height] parameter in group 1.
b) The horizontal center position of the video pasted on Side H. At –100.00,
the center is at the left edge of the screen. At +100.00, the center is at the
right edge of the screen.
c) The vertical center position of the video pasted on Side H. At –100.00, the
center is at the bottom edge of the screen. At +100.00, the center is at the
top edge of the screen.
Setting the background image
When the switcher signal format is 3840×2160P 2SI, you
can set a color signal to use as the background of DME
wipes.
Note
When the signal format is other than 3840×2160P 2SI, the
image selected on the utility 2 bus is used.
1
In the M/E-1 >DME Wipe >Edge/Direction menu
(1164), press [DME Bkgd Matte Adjust].
The Matte Adjust menu (1154.1) appears.
2
In the <Edge Matte> group, select one of the
following.
Flat Color: Use a single color signal. Set the
following parameters.
No. Parameter
1 Luminance
2 Saturation
3 Hue
Mix Color: Use a mix color signal.
For details about color mix settings, see "Carrying out
a color mix for the edge fill matte" (page 143).
Note
The color signal for the background image of DME
wipes is shared with the color matte settings for wipe
edge fills.
a)
b)
c)
Adjustment
Luminance
Saturation
Hue
159

Setting DME Wipe Modifiers

You can apply various modifiers, such as setting the wipe
direction or the pattern position.
For an overview of modifiers and supported pattern
numbers, see "DME Wipe Pattern Variation and
Modifiers" (page 156).
Specifying the DME wipe direction
(Direction)
You can specify the DME wipe direction (normal/reverse).
To specify the wipe direction in the menu
1
Open the M/E-1 >DME Wipe >Edge/Direction menu
(1164).
2
In the <Direction> group, specify the DME wipe
direction.
Normal: DME wipe in the normal direction.
Normal/Reverse: DME wipe in the normal and
reverse direction alternately for each transition.
Reverse: DME wipe in the opposite direction to
normal.
To specify the DME wipe direction with a button
in the transition control block
In the transition control block of each bank, press the wipe
direction selection buttons.
1)
NORM: Normal
NORM/REV: Normal/reverse
REV: Reverse
1) When the [REV] button is not lit if using the transition control block
(simple type).
Modifying a DME wipe pattern edge (Edge)
1
Open the M/E-1 >DME Wipe >Edge/Direction menu
(1164).
2
In the <Ch Select> group, select the target channels.
For a pattern in 1-channel mode: Select [1st Ch].
For a pattern in 2-channel mode or 3-channel
mode: Select the corresponding channels. You
can select more than one channel at the same time.
3
In the <Edge> group, select the edge type.
Border: Border
Soft Border: Soft border
4
Depending on the selection in step 3, set the following
parameters.