Connecting A Computer; Installing The Vista-Icm; Installing Vista-Icm Hardware - Honeywell VISTA-ICM Installation And Setup Manual

VISTA-ICM Installation and Setup Guide

Connecting a Computer

Verify the network installation by connecting a computer to the network. Plug the
computer to one of the Ethernet ports on the router, or a hub or switch that is connected
to the router. Verify that the computer can obtain an IP address and access the router.
Refer to the networking instructions provided by the computer manufacturer to connect
the computer to the network. Each operating system will have a different sequence of
steps to configure the network. The following general tasks must be performed
regardless of the computer or operating system vendor:
1. Connect the Ethernet cable to the Ethernet jack on the computer. If the computer
does not have an Ethernet jack, you will need to install a Network Interface Card
(NIC) or an external USB network adapter. The link LED will light when the
computer is linked to a hub with a good Ethernet cable.
2. Verify the network connection of the computer by visiting a web site on the Internet.
http://www.honeywell.com
Type
sure the computer network settings are valid. If the home does not have an Internet
connection, you can still setup the VISTA-ICMs, but you may need to verify the
computer settings manually.

Installing the VISTA-ICM

Installing VISTA-ICM Hardware

NOTE: Momentary depression of the VISTA-ICM reset button soft-resets the VISTA-
ICM; a 5-second hold sets factory defaults, including static IP address if used.
To connect a VISTA-ICM:
1. Place the VISTA-ICM in a suitable clean, dry, ventilated indoor location, near the
equipment to be controlled. The VISTA-ICM is not designed to be installed in an
attic, crawl space, or an outdoor location.
2. Wire the VISTA-ICM to the Vista security panel using the keypad wiring guidelines
provided in the security panel instructions. The Vista VISTA-ICM is powered by the
Vista security panel, and requires 200mA from the Vista power supply.
NOTE: Supported security panels include any Vista control panel that supports
addressable keypads using ECP. Connect the Ethernet port on the VISTA-ICM to the
network hub or switch using a standard CAT5 cable.
NOTE: The VISTA-ICM does not support global features and must be assigned to a
particular partition.
in the address bar of the web browser to make
Figure 3 - VISTA-ICM Connections
4