Page 1
JANOME ELECTRO PRESS JP-104 JP-204 JP-504 JP-1004 JP-1504 JP-3004 JP-5004 JPH-104 JPH-204 JPH-504 JPH-1004 JPH-1504 JPH-3004 JPH-5004 JPU-104 JPU-204 JPU-504 JPU-1004 JPU-1504 JPU-3004 JPU-5004 JPU-8004 For Your Safety Thank you for purchasing the Electro Press. *Read this manual thoroughly in order to properly use this machine.
FOR YOUR SAFETY This volume contains particularly important instructions and notices for safe and proper use of this machine. Please read it thoroughly and be sure to follow the instructions and notices. Instructions for your safety are also included in each operation manual. Please refer to these during actual operation.
Caution When the electro press is being operated or adjusted, keep the operation manuals in a handy place so that you or the operator can refer to them whenever necessary. Safety precautions should not necessarily be limited only to those prescribed in the operation manuals.
Page 4
Be sure to attach this sticker in plain view. 1.2 Notices regarding installation ・ Place the machine on a suitable flat surface that can support its weight. Be sure to leave a space greater than 30cm between the back of the control box equipped with a cooling fan and the wall. Do not cover the cooling fan vent on the top of a stand-alone or head type press.
Page 5
・ Use the machine in an environment where it is not exposed to direct sunlight. Direct sunlight may cause malfunction or defect. ・ Attach the eyebolt and use a crane to transport the machine. ・ Be sure to remove the eyebolt after installing the machine. After removing the eyebolt, tighten the screw provided (JP/JPH-104 and 204, JPU-104 to 1504) or attach the rubber cap provided (JP/JPH-504, 1004) to the eyebolt fixing hole.
Page 6
・ Do not disassemble or modify the machine. This can cause electric shock or malfunction of the machine. ・ Place the control box on a flat surface more than 80 cm above the floor so that it is easier to operate. ・...
2. WORKING ENVIRONMENT 2.1 Operation inside the safeguard ・ When putting your hand inside the safeguard, be sure to turn off the motor power to the machine by enabling the emergency stop device and follow the safety precautions below. ・ Place a “Do Not Operate” sign on the start switches. ・...
Page 8
3. TRIAL OPERATION AND AUTOMATIC OPERATION Please check the following before trial operation or automatic operation of the electro press: ・ That no obstacle is inside or around the electro press working area. ・ That the teaching pendant and tools are in place. ・...