S4585D - Honeywell 1000 Series Instruction Sheet

SPECIFICATIONS INTERMITTENT PILOT IGNITION CONTROL S4585D
Model
Suffix D: fan assisted, intermittent pilot burner ignition
Supply voltage
220 ... 240 Vac, 50/60 Hz
Power consumption
4 VA
Humidity
90% RH max. at 40 _C non condensing
Ambient temperature
0 ... 60 _C
Electrical rating
Fan: 220 ... 240 Vac, 50/60 Hz, 1 A, cos ♥ > 0.6
No flame indicator: 220 ... 240 V, 1 mA max
Electrical connection
High voltage spark/flame sensing single rod:
2.8 x 0.5 mm spade terminal
PCB connectors:
Molex 3003 series suitable for Molex 3001 female
cable connector
Housing (degree of protection)
See page 29
Timing (depending of O.S. number)
Self check time (T ): 1.5 s
c
Safety time (T ): infinite
s
Side connections**
Side connections**
EN1R- -9161 0006R10- -NE
12 11
LM
L
Fig. 45. Connection diagram S4585D wired up in atmospheric application
11
12
LM
L
Fig. 46. Connection diagram S4585D wired up in fan assisted application
Flame sensing
Min flame current: 1.0 ←A
Response time on: > 0.2 s
Response time off (T
Phase--Phase mains trafo input: 220 ... 240 > 0.1 VA
Ignition
Spark voltage: > 12 kV at 40 pF load
Repetition rate: 1 ... 4 Hz
Max spark gap: 3.5 mm
Length ignition and flame sensing cable
0.5 m max.
Length of wiring for external components
1 m max.
Recommended flame sensor
Q371/Q385 "2000 series"/Q389/Q395 intermittent ignition pilot
burner
Maximum pilot burner output
250 Watt
No flame indicator
Required impedance: > 100 kτ
No flame indication time
T : > 10 s
NF
10
9 8
NF
Optional
N
LM -- Limiter
NF -- No flame indicator
** Alternative side connection for models with combined flame
detection/high voltage. See page 5 fig. 6.
10
9 8
NF
Optional
LM -- Limiter
P -- Air proving switch
N
NF -- No flame indicator
** Alternative side connection for models with combined
flame detection/high voltage. See page 5 fig. 6.
26
): < 1.0 s
FR
6 5 3
6 5
3
¯
2
1
2 1
P
¯