Table of Contents
Advertisement
14
RSPSupply - 1-888-532-2706 - www.RSPSupply.com
http://www.RSPSupply.com/p-8466-MDS-P60-Compact-Enclosure-(One-Radio).aspx
2. Hold the packaged unit up to the wall in the desired mounting position.
Have an assistant mark the four mounting holes with a pencil or marker.
(The marks should be placed in the center of the wide portion of the
mounting clips.)
3. Prepare the mounting surface for the fasteners to be used. (If using lag
screws, a small pilot hole at each mark will allow easier starting of the
screw.)
4. Insert the screws part way into the wall, leaving enough space to slide the
enclosure mounting clips onto the screws. Hang the packaged system
enclosure onto the four screws and tighten the screws securely. Do not
over-tighten.
Figure 4
shows a typical wall mount installation.
MOUNTING CLIP DETAIL
(4 REQ’D)
FLAT
WASHER
LAG SCREW
ATTACHED TO BACK
OF MDS xx60
A
ENCLOSURE WITH
10-32 SCREW
(SEE TEXT)
COAXIAL CABLE
TO ANTENNA
Figure 4. Typical Wall Mounted Installation (MDS P-60)
MDS P-60/P-60 HL Reference Manual
MOUNTING
CLIP
9.0"
22.86 cm
MDS 05-2818A01, Rev. C
13.38"
34 cm
TO PRIMARY
POWER
(CONDUIT)
TO DATA
EQUIPMENT
(RTU)
Advertisement
Table of Contents
