Installing Hook; Operation - Makita XBP03 Instruction Manual

Installing hook

Optional accessory
CAUTION:
Do not use the hook for other pur-
pose than temporarily hanging the tool. Doing so
may cause the hook come off from the tool and result
in personal injury.
Hook is useful for hanging the tool. Hang the tool on a
pipe vice or other suitable, stable structure.
To install the hook, set the hook alongside the groove
and tighten it with two screws.
► 1. Hook 2. Screws

OPERATION

CAUTION:
Always insert the battery cartridge all the
way until it locks in place. If you can see the red indicator on the
upper side of the button, it is not locked completely. Insert it fully
until the red indicator cannot be seen. If not, it may accidentally fall
out of the tool, causing injury to you or someone around you.
CAUTION:
Never hold the tool body or guards.
Hands may slip from these locations and contact with
the band saw blade. It may result in personal injury.
CAUTION:
Make sure to hold the tool firmly
when turning on or off the tool or when cutting.
Otherwise the tool may fall and cause personal injury.
NOTE: When cutting metal, wearing gloves is recom-
mended to protect your hands from hot flying chips.
For stable cut, always keep at least two teeth in the cut.
Apply the band saw blade to the suitable cutting posi-
tion on the workpiece as illustrated.
1
2
1. Hold the tool as illustrated.
Before turning on the tool, always make sure that the
stopper plate contacts the workpiece and the band saw
blade is clear of the workpiece.
8 ENGLISH