8.
Reinstall the screws removed in step 2 into the standoffs at the bottom of the IPOTS-COM.
Align holes onto plastic pins
3 Dip Switches
There are two configurable dip switches on the IPOTS-COM communicator.
SW2
SW3
2
Reinstall screws into standoffs
SW2: 6-position dip switch- FUTURE USE- No configuration necessary.
SW3: 2-position dip switch- Factory Settings- Do not change unless instructed to do so by Honeywell.
IPOTS-COM Installation Document — P/N LS10184-000GE-E:B 6/6/2018
Cable header
Snap onto PCB spacer