Storing The Camera Settings In Memory; Preset Feature; Storing The Camera Status; Recalling The Stored Status - Sony BRC-X400 Operating Instructions Manual

Storing the Camera Settings
in Memory

– Preset Feature

Settings, including the camera position, zoom,
focus, and backlighting, can be stored in a
preset.
You can also store presets from a web browser.
For details, see "Preset position tab" (page 83).
Notes
The camera supports up to 256 position presets.
The number of positions that are supported will
vary depending on the device used.
– For the RM-IP500 (sold separately), up to
100 positions.
– For the RM-IP10 (sold separately), up to 16
positions.
– For the remote commander (supplied), up to
6 positions.
– For a web browser, up to 256 positions.
For details on the camera settings that can be
preset, see "Preset Items" (page 88).

Storing the camera status

1
Press the PAN-TILT RESET button to reset the
pan/ tilt position.
2
Adjust the position, zoom, and focus of the
camera (See pages 28 and 28).
3
Hold down the PRESET button and press
any of the POSITION buttons, 1 to 6, in
which you want to store the settings.
While holding
down
Before you store the position, zoom, focus, etc.
of the camera, make sure to install and secure
the camera in place to use it properly.

Recalling the stored status

Press any of the POSITION 1 to 6 buttons in which
you have stored the settings.

Clearing the preset memory

Hold down the RESET button and press the
desired POSITION button 1 to 6 for which you
want to clear the settings.
• If you want to retain the previous pan and tilt
• Storing or clearing the settings in POSITION 1
• When you are storing or clearing the settings in
• For details on the items that can be cleared
• When [PRESET MODE] is set to [MODE2] in the
• You can register, call, or delete the preset even
• Note that if you flip the image, the set position
Press the
POSITION
button you
want to set.
29
Note
While holding
down
Notes
positions when the power is turned off and
turned on again, store those positions in
POSITION 1.
takes about 2 seconds longer than for other
positions.
one POSITION, you cannot restore, store or
clear the settings in another POSITION.
from the memory, see "Preset Items"
(page 88).
SYSTEM menu, only the pan/tilt, zoom, and
focus positions of the camera are recalled
(BRC-X400/X401).
while the menu is being displayed. However,
you cannot change the position with the pan/
tilt operation.
will be cleared.
Press the
POSITION
button you
want to clear.