Storing The Camera Settings In Memory; Preset Feature; Storing The Camera Status; Recalling The Stored Status - Sony BRC-X401 Operating Instructions Manual

Storing the Camera Settings
in Memory

– Preset Feature

Settings, including the camera position, zoom,
focus, and backlighting, can be stored in a
preset.
You can also store presets from the Administrator
menu on a web browser. For details, see "Preset
position tab" (page 89).
Notes
The camera supports up to 256 presets. The
number of presets that are supported will vary
depending on the device used.
– For the RM-IP500 (sold separately), up to 100.
– For the RM-IP10 (sold separately), up to 16.
– For the remote commander (supplied), up to 6.
– For a web browser, up to 256 positions.
For details on the camera settings that can be
preset, see "Preset Items and Image Setting File
Items" (page 96).

Storing the camera status

1
Press the PAN-TILT RESET button to reset the
pan/ tilt position.
2
Adjust the position, zoom, and focus of the
camera (See pages 28 and 28).
3
Hold down the PRESET button and press
any of the POSITION buttons, 1 to 6, in
which you want to store the settings.
While holding
down
Before you store the position, zoom, focus, etc.
of the camera, make sure to install and secure
the camera in place to use it properly.

Recalling the stored status

Press any of the POSITION 1 to 6 buttons in which
you have stored the settings.

Clearing the preset memory

Hold down the RESET button and press the
desired POSITION button 1 to 6 for which you
want to clear the settings.
• If you want to retain the previous pan and tilt
• Storing or clearing the settings in PRESET 1
• When you are storing or clearing the settings in
• For details on the items that can be cleared
• When [PRESET MODE] is set to [MODE2] in the
• You can register or delete the preset even while
• When [PRESET MODE] is set to [TRACE] in the
• Note that if you change the image flip setting,
Press the
POSITION
button you
want to set.
29
Note
While holding
down
Notes
positions when the power is turned off and
turned on again, store those positions in
PRESET 1.
takes about 2 seconds longer than for other
preset operations.
one PRESET, you cannot restore, store or clear
the settings in another PRESET.
from the memory, see "Preset Items and Image
Setting File Items" (page 96).
SYSTEM menu, only the pan/tilt, zoom, and
focus positions of the camera are recalled
(BRC-X400/X401).
the menu is being displayed. However, you
cannot perform the pan/tilt operation.
SYSTEM menu, the PTZ trace function works
(BRC-X400/X401). For details, see "Storing
Camera Pan/Tilt and Zoom Operations – PTZ
TRACE function (BRC-X400/X401)" (page 30).
the set preset will be cleared.
Press the
POSITION
button you
want to clear.