NEC UNIVERGE SV8300 Command Manual page 371

COMMAND CODE TITLE:
35
Y
No. MEANING
270 Dial Tone (DT) sending to
calling party of opposite
office when receiving the
SETUP ACK message by
Overlap Sending-Q-SIG
[Russia Only]
NOTE: This command should be assigned to outgoing trunk route.
271 Progress Description by
Overlap Sending-Q-SIG
[Russia Only]
NOTE 1: This command is effective when the second data of CM35 Y=270 is set to "1".
NOTE 2: This command should be assigned to outgoing trunk route.
272 Progress Description by
Overlap Receiving-Q-SIG
[Russia Only]
NOTE 1: This command is effective when the second data of CM35 Y=244 is set to "0".
NOTE 2:
This command should be assigned to incoming trunk route.
273 Sending the called party
number to outgoing trunk
route before receiving all
digits of the called party
number in tandem connec-
tion (Q-SIG to Q-SIG)
[Russia Only]
NOTE:
This command should be assigned to incoming trunk route of tandem office.
TRUNK ROUTE DATA
DATA
0 To send DT of own office
1 To send DT of own office when the received
Progress Description is not same as the Progress
Description assigned by CM35 Y=271
(Not sent when Progress Description is same as
the Progress Description)
2 To send DT from opposite office
(Not sent when DT is not sent from opposite
office)
3 Not sent
1 Progress Description 1
4 Progress Description 4
8 Progress Description 8
15 No data
1 Progress Description 1
4 Progress Description 4
8 Progress Description 8
15 No data
0 To send
1 Not sent
SETTING DATA
MEANING
3-315
CM35
: Default
RELATED
COMMAND
CM35 Y=270
CM35 Y=244
Continued on next page
NWA-033623-001 Rev.8.1
91ch3003.fm
JULY/18/2008