NEC UNIVERGE SV8300 Command Manual page 37

Hide thumbs Also See for UNIVERGE SV8300:

Table of Contents

Do not change or delete the My Line number (set by CM10 Y=00) of the CAT, during CAT mode.

There are no limitations on the number of Multiline Terminals in the system that can be programmed

to allow CAT capability. However, the number of Multiline Terminals that can be placed into CAT

mode, at the same time, is two.

If no key operation is executed for about 10 minutes, the CAT mode is canceled.

When a Multiline terminal is displayed "COMMAND=

pressing Exit key. In other cases, the behavior of pressing EXIT key is similar to the behavior of

Soft Phone cannot be used for CAT.

CAT and Dynamic Dial Pad cannot be used at the same time.

CAT and Preset Dialing can be used at the same time.

" on CAT mode, CAT mode is finished by

Chapter 1 HOW TO USE CAT

NOTICE ON CAT MODE

NWA-033623-001 Rev.8.1

JANUARY/14/2011