Replacement Parts - Honeywell SEC-H-600 Installation Instructions Manual

REPLACEMENT PARTS

Servicing the Security Controller may call for replacement parts. There are three categories of parts:
• Non-replaceable Parts
• Standard Replacement Parts
• New Replacement Units
Non-replaceable Parts
Other than the parts listed in the replacement parts sections, there are no serviceable components on the base assembly.
Memory
Any addition, modification, or replacement of memory components requires software configuration and is not a field upgrade.
Fuse
The Security Controller contains a non-user replaceable fuse, soldered on the circuit board. This fuse provides protection from
internal shorts or connection to incorrect power supplies. If the fuse circuitry is suspect, contact your Authorized Systems
Distributor for technical support. See "Returning a Defective Unit," page 35.
Standard Replacement Parts
Standard replacement parts are listed in Table 7 below and can be ordered from stock without restriction. Standard replacement
parts cannot be returned for credit and should be disposed of in an appropriate manner.
Part Number
NPB-BATTERY NiMH Battery Pack (with battery bracket)—see "Replacing the NiMH Battery," page 31.
10429 6-position (end mount) screw terminal connector plug (1), for expansion modules not mounted in-line.
10717 Screw terminal connector, pin-mount, 7-position (2 used), for card reader inputs.
10716 Screw terminal connector, pin-mount, 6-position (2 used), for relay outputs.
10714 Screw terminal connector, pin-mount, 4-position (2 used), for digital inputs, power supply/SLA battery.
10713 Screw terminal connector, pin-mount, 3-position (3 used), for supervised inputs.
10747 4-lead resistor pack (has two internal 1K ohm resistors) for field installation at supervised contacts. One
resistor pack required for each supervised input.
NOTE: Screws used for the Security Controller are standard #6-32
New Replacement Units
To replace a faulty unit, order and install a new SEC-H-600 Security Controller—please note that WEBs-AX Security series
products do not have special "field replacement units," or FRUs, with separate part numbers.
If the faulty SEC-H-600 controller is still in warranty, you can receive credit by returning it to Tridium. Be sure to contact Tridium
for a return authorization (RA) number before shipping an item for return credit. See "Returning a Defective Unit," page 35, for
more details.
NOTE: Before ordering a new SEC-H-600, it is strongly recommended that you contact your normal technical support resource
to eliminate the possibility of a software issue or mis-configuration problem.
Table 7. Standard replacement parts.
Description
x
33
SEC-H-600 SECURITY CONTROLLER
3/8" types, which you can obtain locally if lost.
95-7759—07