Table of Contents
Advertisement
5. Align the standoffs on the MVME1603/1604 board with the
6. Reinstall the MVME1603/1604 assembly in its proper card
7. Replace the chassis or system cover(s), reconnect the system
RAM104 Memory Mezzanine Installation
The RAM104 DRAM mezzanine mounts on top of the PM603 or
PM604 processor/memory mezzanine. To install a RAM104
mezzanine, refer to Figure 1-11 and proceed as follows:
1. Attach an ESD strap to your wrist. Attach the other end of the
2. Perform an operating system shutdown. Turn the AC or DC
Inserting or removing modules with power applied may
!
result in damage to module components.
Caution
Dangerous voltages, capable of causing death, are
!
present in this equipment. Use extreme caution when
handling, testing, and adjusting.
Warning
holes at the edges of the PM603 or PM604 mezzanine, insert
the Phillips screws through the holes in the mezzanine and
the spacers, and tighten the screws.
slot. Be sure the module is seated properly in the backplane
connectors. Do not damage or bend connector pins.
to the AC or DC power source, and turn the equipment
power on.
ESD strap to the chassis as a ground. The ESD strap must be
secured to your wrist and to ground throughout the
procedure.
power off and remove the AC cord or DC power lines from
the system. Remove chassis or system cover(s) as necessary
for access to the VMEmodules.
Hardware Preparation and Installation
1
1-35
Advertisement
Table of Contents
