Table of Contents
Advertisement
Hardware Preparation and Installation
1
Serial Port 3 Clock Configuration (J10)
You can configure Serial port 3 on the MVME1600-001 to use the
clock signals provided by the TXC signal line. Header J10
configures port 3 to either drive or receive TXC. The factory
configuration has port 3 set to receive TXC.
To complete the configuration of the TXC clock line, you must also
set serial port 3 clock configuration header J9 on the MVME760
transition module, described later in this chapter. For details on the
configuration of that header, refer to the MVME760 Transition
Module section or to the user's manual for the MVME760 (part
number VME760UA).
J10
J10
3
2
1
3
2
1
Receive TXC
Drive TXC
(factory configuration)
1-11
Advertisement
Table of Contents
